Toro Multi Pro WM, Руководство оператора

Страница: 16 / 96

Important:
The Multi-Pro WM turf sprayer requires a 4-post ROPS or cab installed with the Workman
vehicle.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Removing the Existing Bed
No Parts Required
Procedure
CAUTION
The full bed weighs approximately 95 kg (210
lb). You can injure yourself if you remove the
bed without aid.
• Do not try to install or remove the bed by
yourself.
• Get the help of 2 or 3 other people or use
an overhead crane.
1. Park the machine on a level surface, engage the
parking brake, and start the engine.
2. Move the hydraulic lift lever forward and lower
the bed until the clevis pins for the cylinder rod
end lift cylinders are loose in the mounting slots
of the bed mounting plates.
3. Release the hydraulic lift lever, set the hydraulic
lift lock lever, and shut off the engine; refer to the
Operator’s Manual of your machine.
4. Remove the lynch pins from the outer ends of
the cylinder rod clevis pins (
Figure 3 ).
g002368
Figure 3
1. Cylinder rod end 4. Lynch pin
2. Bed mounting plate
5. Rear slots (full bed)
3. Clevis pin 6. Front slots (2/3 bed)
5. Remove the clevis pins securing the cylinder
rod ends to the bed mounting plates by pushing
the pins toward the centerline of the machine
(
Figure 3 ).
6. Remove the lynch pins and clevis pins securing
the pivot brackets of the bed to the frame
channels of the machine (
Figure 4 ).
16