Toro Multi Pro 5700-D, Руководство по обслуживанию

Страница: 93 / 248

Removal (Fig. 54)
1. Park the machine on a level surface, engage the
parking brake, and stop the engine. Remove the key
from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. Disconnect one hydraulic hose from the bottom of
the hydraulic reservoir to drain reservoir (see Operator’s
Manual).
4. Disconnect remaining hydraulic hoses from reser-
voir.
Figure 55
2
1
4
3
5. Remove hydraulic reservoir from machine using Fig-
1. Hose (from oil cooler) 3. Hose (to piston pump)
ure 54 as a guide.
2. Hose (from piston pump) 4. Hose (to gear pump)
Inspection
1. Clean hydraulic reservoir with solvent.
2. Inspect reservoir for leaks, cracks, or other damage.
Installation (Fig. 54)
1. Install hydraulic reservoir to machine using Figure 54
as a guide.
2. Lubricate new o–rings and reconnect hydraulic
hoses to reservoir (Fig. 55).
3. Fill reservoir with hydraulic fluid as required (see Op-
erator’s Manual).
4. Operate machine and inspect for leaks.
Hydraulic
System
Multi Pro 5700–D Page 4 – 59 Hydraulic System