Toro Multi Pro 5700-D, Руководство по обслуживанию

Страница: 74 / 248

Wheel Motor Service
8
11
9
19
15
20
18
17
12
13
14
10
1
7
4
5
6
4
5
2
3
16
21
15 to 18 ft–lb
(20 to 24 N–m)
Figure 37
1. Retaining ring 8. Cap screw (6 used) 15. Rotating kit
2. Shaft seal 9. Back plate 16. Cam plate insert
3. Washer 10. Dowel pin 17. Housing
4. Retaining ring 11. Dowel pin (3 used) 18. Speed sensor (RH wheel)
5. Thrust bearing race 12. O–ring 19. O–ring
6. Thrust bearing 13. Needle bearing
20. O–ring
7. Drive shaft 14. Valve plate 21. Needle bearing
NOTE: The wheel motors used on the Multi Pro NOTE: For information on speed sensor installation,
5700–D are very similar. The major difference is the see Traction Speed Sensor in the Service and Repairs
speed sensor installed in the right side wheel motor. Ser- section of Chapter 5 – Electrical System.
vice of the left and right motors requires the same proce-
dure.
NOTE: For service of the wheel motors, see the Eaton
Model 74318 and 74348 Piston Motors: Fixed Displace-
ment, Valve Plate Design Repair Information at the end
of this chapter.
Hydraulic System Page 4 – 40 Multi Pro 5700–D