Toro Multi Pro 5700-D, Руководство по обслуживанию

Страница: 131 / 248

Rev. D Multi Pro 5700--D Page 6 -- 3 Spray System
General Information
Precautions Concerning Chemicals Used in Spray System
Chemicals can injure persons, animals, plants, soil, or
other property. To eliminate environmental damage and
personal injury:
1. Select the proper chemical for the job.
2. Carefully read the directions printed on the chemical
manufacturer’s labels before handling chemicals. In-
structions on chemical manufacturer’s container labels
regarding mixing proportions should be read and strictly
followed.
3. Keep spray material away from skin. If spray material
comes in contact with a person, wash it off immediately
in accordance with manufacturer’s recommendations
(container labels and Material Safety Data Sheets).
4. Always wear protective clothing, chemical resistant
gloves, eye protection, and other personal protective
equipment as recommended by the chemical manufac-
turer.
5. Properly dispose of chemical containers, unused
chemicals, and chemical solution.
Precautions for Removing or Adjusting Spray System Components
1. Stop the vehicle and set the parking brake.
2. Shut off the vehicle’s engine and remove the key
from the ignition switch.
3. Disengage all power and wait until all moving parts
have stopped.
4. Remove chemicals from pump, hoses, and other
spray components. Thoroughly neutralize and rinse
spray system before loosening or removing any spray
system component(s).
5. Make sure line pressure is relieved before loosening
any system component.
O--Ring Seal Kit
Part Number: 106--4846
The O--Ring Seal Kit includes an assortment of O--rings
used for sealing spray control valves on machines with
serial numbers below 310000000. It is recommended
that O--rings be replaced every two (2) years or whenev-
er a fitting is loosened.
Figure 1
SPRAYER
O--RING SEAL KIT
PART NO. 106--4846
Spray System