Toro Multi Pro 5700-D, Руководство по обслуживанию

Страница: 192 / 248

Multi Pro 5700–D Chassis
Page 7 – 12
Brake Inspection and Repair
1. Brake housing (LH shown)
2. Seal
3. Pull
rod
4. Clevis pin
5. Link
6. Hitch pin (2 used)
7. Stationary
disc
8. Rotating disc
9. Retaining ring
10. Gasket
11. Rotating actuator
12. Extension spring (3 used)
13. Ball (3 used)
14. Plug (2 used)
15. O–ring
Figure 9
3
2
4
5
6
7
8
9
10
14
13
12
11
15
1
8
7
5
Brake Inspection and Repair (Fig. 9)
1. Scrape gasket material (10) from brake housing and
planetary wheel drive mounting surfaces.
2. Remove retaining ring (9).
3. Remove four stationary discs (7) and three rotating
discs (8).
4. Remove three extension springs (12).
5. Remove actuator assembly (3, 4, 5, 6 and 11) and
three balls (13).
6. Remove seal (2) from brake housing.
7. Wash parts in cleaning solvent. Inspect components
for wear or damage.
8. Reverse steps 2 – 6 to assemble brakes, installing
new parts as necessary. Install a new seal (2).
9. Use a new gasket (10) when installing the brake as-
sembly to machine.