Toro Multi Pro 5700-D, Руководство по обслуживанию

Страница: 26 / 248

Rev. D
Multi Pro 5700--D
Page 3 -- 8
Kubota Diesel Engine
Exhaust System
Figure 6
1. Muffler gasket
2. Lock washer (4 used)
3. Cap screw (4 used)
4. Exhaust pipe
5. Heat shield (6 used)
6. Cap screw (2 used)
7. Lock washer (2 used)
8. Exhaust pipe bracket
9. Flange head screw
10. Flat washer
11. Flange nut
12. Exhaust pipe hanger
13. Cap screw
14. Lock washer
15. Flat washer
16. Flange nut
17. Cap screw
18. Muffler
19. Muffler clamp
20. Tailpipe
21. Muffler heat shield (2 used)
FRONT
RIGHT
12
18
19
21
20
2
3
8
9
10
4
11
7
5
1
6
5
5
12
11
10
9
13
14
16
15
17
13
13
14
14
15
15
19
SERIAL NUMBER BELOW 310000000
Removal (Fig. 6 or 7)
CAUTION
The muffler and exhaust pipes may be hot. To
avoid possible burns, allow the engine and ex-
haust system to cool before working on the ex-
haust system.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Support muffler from below to prevent it from falling.
3. Remove exhaust system components as required
using Fig. 6 (machines with serial number below
310000000) or Fig. 7 (machines with serial number
above 310000000) as a guide. During removal, note
location of fasteners in rubber exhaust system hangers
so hangers are properly assembled.
NOTE: On machines with serial number below
310000000, the muffler inlet is offset and the muffler out-
let is centered.
4. Locate and retrieve muffler gasket if exhaust pipe
was removed.
5. Remove heat shields, hangers and brackets from
exhaust components as needed.