Toro GreensPro 1240, Руководство по обслуживанию

Страница: 151 / 186

Disassembling the Drive Roller (GreensPro 1240) (continued)
2. Loosen the set screws and remove the bearing collars and bearing
assemblies.
3. Remove the bolts, lock washers, and flat washers that secure the roller
shafts to the drive roller, and remove the roller shafts.
Assembling the Drive Roller (GreensPro 1240)
Refer to Figure 71 for this procedure.
1. Install the roller shafts with the bolts, lock washers, and flat washers.
Note: It may be necessary to re-position the bearings and bearing collars
during the drive roller installation.
2. Position the bearing collars on the roller shafts in locations recorded during
disassembly and lightly tighten the set screws.
3. Position the bearings on the roller shafts against bearing collars and lightly
tighten the bearing collar set screws.
4. Lubricate the bearing grease fittings until grease is visible on the outer
surface of the bearing. Wipe away any excess grease.
GreensPro ™ 1240/1260 Page 7–25 Chassis: Service and Repairs
14211SL Rev A