
g230770
Figure 25
1.
Hairpin cotter
2.
Hitch pin
2.
Secure the assembly to the hitch receiver using
the hitch pin and hairpin cotter attached to the
receiver (
3.
Pull out the kickstand locking pins on both sides
of the machine, rotate them 90 degrees so that
they are disengaged, and raise the kickstand
(
). Engage the knobs and ensure that
the pins snap into position.
g230843
Figure 26
1.
Kickstand locking pin in
the engaged position
3.
Kickstand in the blower
operating position
2.
Kickstand locking pin in
the disengaged position
4.
Kickstand in the blower
storage position
Removing the Blower
1.
Park the machine on a level surface, disengage
the PTO, engage the parking brake, and
move the motion-control levers outward to the
N
EUTRAL
-L
OCK
position.
2.
Shut off the engine and remove the key.
3.
Disconnect the blower hydraulic hoses from the
quick-disconnect couplings on the Low Flow Kit.
4.
Lower the blower; refer to
(page 12)
.
5.
Remove the belt from the clutch.
Note:
If needed, use a drive ratchet (1/2 inch)
to move the left idler pulley (
g231579
Figure 27
1.
Drive ratchet
2.
Pulley
6.
Lift the blower assembly off the bushing
assemblies on the machine.
14