
10.
Use a carriage bolt (3/8 x 1 inch) and a locknut
(3/8 inch) to install the stop bracket to the right
side of the machine (
). Torque the bolt
to 37 to 45 N∙m (27 to 33 ft-lb).
g250341
Figure 13
1.
Locknut (3/8 inch)
3.
Carriage bolt (3/8 x 1 inch)
2.
Stop bracket
11.
Remove the hitch pin and cotter pin from the
A-frame and use it to install the hitch receiver
(
). Ensure that the pin locks the
A-frame to the cross tube.
g230752
Figure 14
1.
Hitch receiver
3.
Cotter pin
2.
Hitch pin
12.
Move the blower in front of the machine and lay
the belt underneath the machine so that it is
lined up with the clutch (
g230767
Figure 15
1.
Blower assembly
3.
Clutch
2.
Belt
13.
Place the blower assembly forks onto the
bushing assemblies (
).
g250511
Figure 16
14.
Route the belt to the idler pulley.
Important:
Ensure that the wide side of the
belt contacts the pulley as shown in
. Use the shoulder bolt as a guide for the
belt.
10