Toro 74991 Z Master Professional 5000 Series, Руководство оператора

Страница: 60 / 76

G008968
1
2
Figure 92
Bottom view of the machine
1. Filter locations 2. Hydraulic filter
6. Apply a thin coat of hydraulic fluid to the rubber gasket
on the replacement filter (
Figure 92 ).
7. Install the replacement hydraulic filter.
8. Install the pump-drive belt and the mower belt.
9. Remove the jack stands and lower the machine ( Figure
91 ).
10. Add fluid to the hydraulic reservoir and check for any
leaks.
11. Clean up any spilled fluid.
12. Start the engine and let it run for about 2 minutes to
purge air from the system.
13. Shut off the engine and check for leaks.
14. Check the fluid level while the oil is cold.
15. If required, add fluid to the hydraulic reservoir.
Note:
Do not overfill.
Mower Deck
Maintenance
Leveling the Mower Deck
Setting Up the Machine
Note:
Ensure that the mower deck is level before matching
the height of cut (HOC).
1. Position the mower on a flat surface.
2. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
EUTRAL
-
LOCK
position,
and set the parking brake.
3. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Check the pressure of the drive tires.
Note:
Proper inflation pressure for the tires is 90 kPa
(13 psi).
5. Position the mower deck to the 76 mm (3 inch)
height-of-cut position.
Leveling the Deck
1. Position the mower on a flat surface.
2. Shut off the engine, wait for all moving parts to stop,
remove the key, and engage the parking brake.
3. Check the pressure in the drive tires.
Note:
Proper inflation pressure for the tires is 90 kPa
(13 psi).
4. Position the transport lock in the latching position.
5. Push the deck lift pedal all the way forward and the
deck will latch at the 14 cm (5-1/2 inch) transport
position (
Figure 93 ).
Figure 93
1. Deck-lift pedal 3. Transport lock
2. Height-of-cut pin
60