Toro 74991 Z Master Professional 5000 Series, Руководство оператора

Страница: 20 / 76

Operating the Mower
Blade-Control Switch (PTO)
The blade-control switch (PTO) starts and stops the mower
blades and any powered attachments.
Engaging the Blade-Control Switch
(PTO)
Note:
Engaging the blade-control switch (PTO) with the
throttle position at half or less causes excessive wear to the
drive belts.
G008945
Figure 14
Disengaging the Blade-Control Switch
(PTO)
G009174
Figure 15
Operating the Throttle
You can move the throttle control between F
AST
and S
LOW
positions ( Figure 16 ).
Always use the F
AST
position when turning on the mower
deck with the blade-control switch (PTO).
G008946
Figure 16
Operating the Ignition Switch
1. Turn the ignition key to the S
TART
position ( Figure 17 ).
Note:
When the engine starts, release the key.
Important:
Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, wait 15 seconds between attempts. Failure to
follow these instructions can burn out the starter
motor.
Note:
You may need multiple attempts to start the
engine when you start it the first time after the fuel
system has been without fuel completely.
ST
ART
RUN
ST
OP
G008947
Figure 17
2. Turn the ignition key to the S
TOP
position to shut off
the engine.
Using the Fuel-Shutoff Valve
The fuel-shutoff valve is located under the seat. Move the
seat forward to access it.
Close the fuel-shutoff valve for transport, maintenance, and
storage.
Ensure that the fuel-shutoff valve is open when starting the
engine.
G008948
1
2
Figure 18
1. On 2. Off
20