Toro 74991 Z Master Professional 5000 Series, Руководство оператора

Страница: 47 / 76

Figure 66
1. ROPS knob (locked
position) 3. Roll bar in the upright
position
2. Pull the ROPS knob out,
and rotate it 90 degrees
to change the roll bar
position. 4. Roll bar in the folded
position
Adjusting the Tracking
1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area and move the motion-control
levers to the N
EUTRAL
-
LOCK
position.
3. Move the throttle midway between the F
AST
and S
LOW
positions.
4. Move both motion-control levers forward until they
both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If the machine tracks to the right, loosen the bolts and
adjust the left stop plate rearward on the left T-slot
until the machine tracks straight (
Figure 67 ).
7. If the machine tracks to the left, loosen the bolts and
adjust the right stop plate rearward on the right T-slot
until the machine tracks straight (
Figure 67 ).
8. Tighten the stop plate ( Figure 67 ).
g029647
1
2
3
Figure 67
Left control lever shown
1. Control lever 3. Stop plate
2. Bolt
47