8. Mount the tank/compressor assembly to the right
step frame using 2 bolts (3/8 x 1 inch) and 2 flat
washers (Figure 7).
Figure 7
1.
Right step frame
2.
Tank assembly frame
Note:
You must install the fasteners from the
backside of the step frame.
9. Attach the cover to the tank/compressor assembly
using 4 hex-head bolts (1/4 x 1 inch) and 4 flat
washers that you removed previously.
Workman 200 Spray System
1. Remove the 4 bolts (1/4 x 1 inch) and 4 flat washers
that hold the cover to the tank/compressor assembly
and remove the cover (Figure 8).
Figure 8
1.
Cover
4.
Bolt (1/4 x 1 inch)
2.
Tank/compressor
assembly
5.
Bottom right bolt
3.
Flat washer
2. Set the cover and fasteners aside.
3. Mark a 108 inch supply hose with a black marker at
each end (Figure 9).
Figure 9
1.
Compressor hose
3.
To the mixer tee
2.
Needle valve hose
4. Connect the marked supply hose to the hose barb
at the compressor and the other supply hose to the
hose barb on the needle valve (Figure 9).
5. Secure the hose ends with small hose clamps.
6. Route both of the supply hoses rearward along the
left side of the sprayer to the rear of the machine
following the sprayer wiring harness.
7. Remove the rubber striping on the back side of the
tank cover (Figure 10).
Figure 10
1.
Rubber strip
4.
Mud flap
2.
Tank cover
5.
Bolt (5/16 x 3/4 inch)
3.
Mud flap bracket
6.
Locknut (5/16 inch)
8. Locate the mud flap and mud flap bracket in loose
parts. Install the mud flap to the tank cover. Secure
the flap using the bracket, three bolts (5/16 x 3/4
5
