Figure 23
1250
1.
Plug
3.
Notch (at back)
2.
Switch
4.
Spray control panel
Figure 24
1200
1.
Foam marker switches
2.
Spray control panel
3. Plug the connector with the orange wire for the right
foam solenoid to the right switch and the connector
with the blue wire for the left foam solenoid to the
left switch.
Note:
Ensure that the orientation of the switches
matches what is shown in Figure 23, with the notch
pointing toward the rear of the vehicle.
4. Insert the 15-amp fuse in the corresponding slot in
the fuse block (at the front of the vehicle).
Multi Pro 5600/5700 Turf Sprayer
1. Remove the throttle knob by unscrewing it from the
throttle rod at the center console.
2. Release the latch and remove the switch panel
assembly from the center console assembly
(Figure 25).
Figure 25
1.
Control panel
3.
Foam marker switches
2.
Latch
3. Remove the foam marker switch hole plugs.
4. Install the 2 rocker switches into the switch panel.
Note:
Ensure that the notch/hole on the bottom of
each switch is oriented toward the rear of the vehicle.
5. Plug the harness connectors found in the center
console into the foam marker switches.
Note:
The plugs in the harness are marked: Boom
foam RS/LS switch. The left connector has a orange
wire with a blue stripe and the right connector has a
blue wire with a gray stripe.
6. Install the switch panel and secure the latch.
7. Screw the throttle knob onto the throttle rod until
it is hand tight.
8. Insert the 15-amp fuse in the corresponding slot in
the fuse block (at the front of the vehicle).
Workman 200 Spray System
1. Loosen the 4 screws securing the front panel to the
control box (Figure 26).
2. Remove the front panel expose the inside of the
control box (Figure 26).
10
