slow or no foam production, remove and clean the
strainer.
1. Position the vehicle on a level surface, set the parking
brake, stop the pump, stop the engine, and remove
the ignition key.‘
2. Relieve pressure within tank by flipping the pressure
release valve into the upright position (Figure 32).
3. Clamp liquid hose and remove from hose barb.
4. Unscrew nozzle body and hose barb from nozzle
adapter and solenoid assembly. Remove strainer
(Figure 34).
Important:
Use a back up wrench on the nozzle
adapter while unscrewing the nozzle body
to avoid unnecessary torque on the solenoid
assembly.
Figure 34
1.
Hose barb
4.
Nozzle adapter
2.
Nozzle body
5.
Solenoid assembly
3.
Strainer
6.
Liquid hose
5. Inspect and clean strainer. Replace if necessary.
6. Assemble strainer and nozzle body/hose barb
as shown in Figure 34 and install into nozzle
adapter/solenoid assembly.
7. Attach liquid hose to hose barb and un-clamp.
8. Flip pressure release valve to the down position.
If the problem persists, please contact your local
Authorized Toro Distributor.
Storage
1. Remove the couplers on top of the tank.
2. Loosen and unhook the foam marker tank strap.
3. Remove the tank from the bracket, remove the tank
lid, and empty the contents of the tank.
4. Rinse and flush the inside of the tank.
5. Install the lid on the tank.
6. Attach the couplers.
7. Strap the tank into place.
16
