3. With the machine on level surface, position one blade
front-to-rear. Measure at
A
and from level surface to
the cutting edge of the blade tips (Figure 69). For 36
inch mower decks use Figure 70.
Figure 69
40 inch Mower Deck shown
1.
Measure from a level
surface
2.
Measure blade at point
A
Figure 70
36 inch Mower Deck shown
4. The measurement should be 4 inch (101.6 mm).
5. If it does not measure correctly:
A. Adjust the rear tire pressure.
B. Adjust the caster fork spacers.
C. Adjust the front mower deck support pins.
6. Check the carrier frame front-to-rear pitch.
Replacing the Grass Deflector
An uncovered discharge opening could allow
the lawn mower to throw objects in the
operator’s or bystander’s direction and result
in serious injury. Also, contact with the blade
could occur.
Never operate the lawn mower unless you install
a cover plate, a mulch plate, grass deflector or
bagger.
1. Remove the locknut, bolt, spring and spacer holding
the deflector to the pivot brackets (Figure 71).
Remove damaged or worn grass deflector.
Figure 71
1.
Bolt
5.
Spring installed
2.
Spacer
6.
Grass Deflector
3.
Locknut
7.
L end of spring, place
behind deck edge before
installing bolt
4.
Spring
8.
J hook end of spring
2. Place spacer and spring onto grass deflector. Place
the
L
end of spring behind deck edge.
Note:
Make sure the
L
end of spring is installed
behind deck edge before installing the bolt as shown
in Figure 71.
3. Install bolt and nut. Place the
J
hook end of spring
around grass deflector (Figure 71).
Important:
The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
44
Содержание 39094
