Toro 39094, Руководство оператора

Страница: 30 / 52

Electrical System
Maintenance
Servicing the Fuse
The electrical system is protected by a fuse. It requires
no maintenance. If the fuse blows, check the component
or circuit for malfunction or a short. To replace the fuse,
pull out on the fuse (Figure 37) to remove or replace it.
Figure 37
1. Fuse, 7.5 amp, blade type
Drive System
Maintenance
Adjusting the Control Bar
1. Check the gap between upper control bar and
fixed bar with wheel drive fully engaged. The gap
should be approximately 1 to 1-1/4 inch (25-32 mm)
(Figure 38).
Note:
The upper control bar and fixed bar must be
parallel when the upper control bar is in the engaged,
drive, neutral, or brake positions.
Figure 38
1. Upper control bar 4. Handle
2. Parking brake lever 5. 1 to 1-1/4 inch (25-32mm)
gap
3. Fixed control bar
2. Check the operation. If adjustment is required,
remove hairpin cotter, washer and clevis pin securing
control rod fitting to idler bracket (Figure 39).
3. Thread the rod fitting up or down on the rod until
the proper position is attained and install the rod
fitting to the idler bracket with the clevis pin, washer
and hairpin cotter.
30