Toro 39094, Руководство оператора

Страница: 18 / 52

1. After adjusting the height-of-cut, check the
anti-scalp rollers so that there is a minimum of
3/8 inch (10 mm) clearance above the ground
(Figure 13, Figure 14, Figure 15).
2. If adjustment is needed, remove the bolt, washers
and nut (Figure 13, Figure 14, Figure 15).
3. Select a hole position so the anti-scalp rollers are
a minimum of 3/8 inch (10 mm) off the ground
(Figure 13, Figure 14, Figure 15).
4. Install the bolt and nut (Figure 13, Figure 14,
Figure 15).
Figure 13
40 inch Mower Deck
1. Mower deck 4. Anti-scalp rollers
2. Bolt 5. Nut
3. Spacer
Figure 14
40 inch Mower Deck
1. Mower deck 4. Bushing
2. Bolt 5. Anti-scalp rollers
3. Spacer 6. Nut
Figure 15
36 inch Mower Deck
1. Mower deck 4. Anti-scalp rollers
2. Bolt 5. Nut
3. Spacer
5. In certain mowing conditions and terrain, a
mismatch of cutting height may be seen. Adjusting
the outside anti-scalp rollers to the minimum setting
of 3/8 inch (10 mm) will help prevent the mower
deck cutting too low on the outside and minimize
the mismatch.
Adjusting the Handle Height
The handle position can be adjusted to match the
operator’s height preference.
18