
4.
Adjust the length of the threaded link to 19 cm (7-1/2
inches) and tighten the jam nuts (
Figure 9
1.
Length of threaded link—19 cm (7-1/2 inch)
5.
Secure the rod end of the threaded link to the
link-support assembly with a bolt (1/2 x 1-1/2 inch)
and locknut (1/2 inch) as shown in
Figure 10
1.
Threaded link
2.
Link-support assembly
6.
Mount the stationary end of the hydraulic cylinder to
the underside of the frame cross-member bracket with
a pivot pin (
Figure 11
1.
Hydraulic cylinder
(stationary end)
3.
Pivot pin
2.
Grease fitting
7.
Thread a grease fitting into the end of the pivot pin
(
).
Note:
Position the grease fitting as shown in
Figure 12
1.
Pivot pin
3.
Angle of grease fitting—45
degrees
2.
Grease fitting
6