
3.
Mount the lift-arm assembly to the rear frame
members, with 2 bolts (7/8 x 4-1/2 inch), 2 jam nuts
(7/8 inch), and as many spindle washers as necessary
to evenly shim between the right and left sides of the
lift arm and rear frame members.
Note:
Position the components as shown in
Figure 3
1.
Bolt (7/8 x 4-1/2 inch)
3.
Spindle washer
2.
Lift-arm assembly
4.
Jam nut
4.
Torque the bolts and locknuts 518 to 648 N-m (382
to 478 ft-lb).
5.
Adjust the length of the threaded link to 19 cm (7-1/2
inches) and tighten the jam nuts (
Figure 4
1.
Length of threaded link—19 cm (7-1/2 inches)
6.
Secure the threaded link rod end to the cylinder-support
assembly with a bolt (1/2 x 1-1/2 inch) and locknut
(1/2 inch) as shown in
.
Figure 5
1.
Lift adapter
2.
Cylinder-support
assembly
7.
Mount the loose end of the hydraulic cylinder to the
cylinder-support assembly with the cylinder-mount
pivot pin, bolt (3/8 x 1 inch), and nut (3/8 inch) as
shown in
.
Figure 6
1.
Grease fitting
3.
Hydraulic cylinder
(stationery end)
2.
Pivot pin
8.
Thread a grease fitting into the end of the pivot pin as
shown in
.
4