Toro 30339, Руководство оператора, Страница: 23 / 52

23
Important
All four hairpin cotter pins must be in the
same hole location and with the correct number of spacers
for a level cut.
2
1
3
m-
4
m–5230
2
4
1
5
Figure 16
1. Carrier Frame
2. Hairpin Cotter
3. Front height–of–cut post
4. Spacers
5. Back height–of–cut post
Adjusting Center Gage Wheels
The gage wheels must be adjusted in the proper hole
location for each height-of-cut position.
1. After adjusting height-of-cut remove bolt, washers and
nut (Fig. 17).
2. Select a hole position so the gage wheels are a
minimum of 3/8 in. (9.5 mm)off the ground for the
height-of-cut to be used (Fig. 17).
3. Reinstall the bolt, washers and nut (Fig. 17).
1
2
3
4
4
m–5213
Figure 17
1. Center Gage Wheels and
Spacer
2. Nut
3. Bolt
4. Washer