Toro 30280, Руководство оператора

Страница: 50 / 64

Before Inspecting or Servicing the
Blades
Park the machine on a level surface, disengage the
blades and set the parking brake. Turn the ignition
key to off. Remove the key and disconnect the
spark plug wires from the spark plugs.
Inspecting the Blades
Inspect the blades every 8 hours.
1. Inspect the cutting edges (Figure 67). If the
edges are not sharp or have nicks, remove and
sharpen the blades. Refer to Sharpening the
Blades.
Figure 67
1. Cutting Edge 3. Wear/slot forming in
curved area
2. Sail 4. Crack in the curved area
2. Inspect the blades, especially the curved area
(Figure 67). If you notice any cracks, wear, or a
slot forming in this area (item 3 in Figure 67),
immediately install a new blade.
Checking for Bent Blades
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Rotate the blades until the ends face forward
and backward (Figure 68). Measure from a
level surface to the cutting edge, position
A , of
the blades (Figure 68). Note this dimension.
Figure 68
1. Measure here from blade
to hard surface
2. Position A
4. Rotate the opposite ends of the blades forward.
5. Measure from a level surface to the cutting
edge of the blades at the same position as
in step 3 above. The difference between the
dimensions obtained in steps 3 and 4 must not
exceed 1/8 inch (3 mm). If this dimension
exceeds 1/8 inch (3 mm), the blade is bent
and must be replaced; refer to Removing the
Blades and Installing the Blades.
50