Toro 30280, Руководство оператора

Страница: 15 / 64

• Cleans the engine while it runs
• Eliminates gum-like varnish buildup in the fuel
system, which causes hard starting
Important:
Do not use fuel additives
containing methanol or ethanol.
Add the correct amount of gas
stabilizer/conditioner to the gas.
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline. To
minimize the chance of varnish deposits in the
fuel system, use fuel stabilizer at all times.
Filling the Fuel Tank
1. Shut the engine off and set the parking brake.
2. Clean around fuel tank cap and remove the
cap. Add unleaded regular gasoline to fuel
tank, until the level is 1/4 to 1/2 inch (6 to 13
mm) below the bottom of the filler neck. This
space in the tank allows gasoline to expand.
Do not fill the fuel tank completely full.
3. Install fuel tank cap securely. Wipe up any
gasoline that may have spilled.
Checking the Engine Oil
Level
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking Oil Level in Engine Maintenance.
Note:
Determine the left and right sides of the
machine from the normal operating position.
Think Safety First
Carefully read all the safety instructions and decals
in the safety section. Knowing this information
could help you or any bystanders avoid injury.
The use of protective equipment for eyes, hearing,
feet and head is recommended.
This machine produces sound levels in
excess of 85 dBA at the operator’s ear and
can cause hearing loss through extended
periods of exposure.
Wear hearing protection when operating
this machine.
Figure 4
1. Warning—wear hearing protection.
Operating the Parking
Brake
Always set the parking brake when you stop the
machine or leave it unattended. Before each use,
check the parking brake for proper operation.
If the parking brake does not hold securely, adjust
it. Refer to Servicing the Parking Brake.
Children or bystanders may be injured if
they move or attempt to operate the machine
while it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Setting the Parking Brake
Pull the parking brake lever rearward (Figure 5).
15