Toro 30280, Руководство оператора, Страница: 33 / 64

Figure 38
1. Fuel shut-off valve 2. Clamp
Servicing the Fuel Filter
Replace the fuel filter after every 200 operating
hours or yearly, whichever occurs first.
Replacing the Fuel Filter
Never install a dirty filter if it is removed from the
fuel line.
Note:
Note how the fuel filter is installed in
order to install the new filter correctly.
Note:
Wipe up any spilled fuel.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Close fuel shut-off valve at the fuel tank
(Figure 38).
4. Squeeze the ends of the hose clamps together
and slide them away from the filter (Figure 39).
Figure 39
1. Hose clamp 3. Filter
2. Fuel line
5. Remove the filter from the fuel lines.
6. Install a new filter and move the hose clamps
close to the filter.
7. Open fuel shut-off valve at fuel tank
(Figure 38).
8. Check for fuel leaks and repair if needed.
9. Wipe up any spilled fuel.
Electrical System
Maintenance
Servicing the Battery
Check the electrolyte level in the battery every
25 hours. Always keep the battery clean and fully
charged. Use a paper towel to clean the battery
case. If the battery terminals are corroded, clean
them with a solution of four parts water and one
part baking soda. Apply a light coating of grease
to the battery terminals to prevent corrosion.
Voltage: 12 V
33