Toro 30280, Руководство оператора

Страница: 19 / 64

Figure 10
1. Drive lever 2. Speed control lever
Driving Backward
From neutral position, slowly squeeze the drive
levers to move rearward (Figure 10).
Bringing the Machine to the
Neutral Position
Always set the neutral lock and parking brake
when you stop the machine.
1. Squeeze the drive levers to neutral position.
2. Set the neutral locks. Refer to Operating
Neutral Locks.
3. Move speed control lever to neutral position.
Note:
The speed control lever can also be
used to bring the mower to neutral position
and then set the neutral locks.
Stopping the Machine
1. To stop the machine, squeeze the drive levers
to neutral position and engage neutral locks.
2. Move speed control lever into neutral.
3. Stop the engine by turning the ignition key to
off.
4. Wait for all moving parts to stop before leaving
the operating position. Set the parking brake.
Children or bystanders may be injured if
they move or attempt to operate the machine
while it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Pushing the Machine by
Hand
The by-pass valves allow the machine to be pushed
by hand without the engine running.
Important:
Always push the machine
by hand. Never tow the machine because
hydraulic damage may occur.
To Push the Machine
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
2. Open the by-pass valve on both pumps by
turning them counter clockwise 1 to 2 turns.
This allows hydraulic fluid to by-pass the
pumps and the wheels to turn (Figure 11).
Note:
Rotate the by-pass valves a maximum
of 2 turns so the valve does not come out of
the body causing fluid to run out.
Figure 11
1. Pump by-pass valve
3. Release the parking brake.
19