Toro 22308, Руководство оператора

Страница: 17 / 40

17
A
C
D
E
B
Figure 18
3. Move the choke lever to the On position (Fig 18, B).
Note: A warm or hot engine may not require choking.
4. Turn the ignition key to the start position until the
engine starts (Fig 18, C).
Important
Do not engage the starter for more than 10
seconds at a time. If the engine fails to start, allow a 30
second cool-down period between attempts. Failure to
follow these instructions can burn out the starter motor.
5. Gradually move the choke lever to the Off position
(Fig 18, D). If the engine stalls or hesitates, engage the
choke again until the engine warms up.
6.
Adjust the throttle lever as desired (Fig 18, E).
Important
If the engine is run at high speeds when the
hydraulic system is cold (i.e., when the ambient air
temperature is near freezing or lower), hydraulic system
damage could occur. When starting the engine in cold
conditions, allow the engine to run in the middle throttle
position for 2 to 5 minutes before moving the throttle to
fast (rabbit).
Note: If outdoor temperature is below freezing, store the
traction unit in a garage to keep it warmer and aid in
starting.
Stopping the Engine
1. Move the throttle lever to the slow position
(Fig. 19, A).
A
B
D
C
Figure 19
2. Lower the loader arm (Fig. 19, B).
3. Turn the ignition key to the stop position (Fig. 19, C).
Note:
If the engine has been working hard or is hot, let it
idle for a minute before turning the ignition key off. This
helps cool the engine before it is stopped. In an
emergency, the engine may be stopped immediately.
4. Remove the ignition key (Fig. 19, D).
Stopping the Traction Unit
To stop the traction unit, release the traction control, move
the throttle lever to slow (turtle), lower loader arm to the
ground, and stop the engine. Set the parking brake and
remove the key.
A child or untrained bystander could attempt to
operate the traction unit and be injured.
Remove the key from the switch when leaving the
traction unit, even if just for a few seconds.
Caution
Moving a Non-functioning
Traction Unit
Important Do not tow or pull the traction unit without
first opening the tow valves, or the hydraulic system will
be damaged.
1. Stop the engine.
2. Open the hood; refer to Opening the Hood, page 23.