Toro 130-5615, Руководство по установке

Страница: 6 / 20

Installing the Windshield
Washer Fluid Kit
For HD-Series Models
Removing the Roof Panel
Roof panel weight: 9.5 kg (21 lb)
1. Remove the 10 bolts (1/4 x 1 inch) and 10 sealing
washers (1/4 inch) that secure the roof panel to the
roof-support brackets of the cab (
Figure 13 ).
Note:
Retain the bolts and washers for installation of
the roof panel in Installing the Overhead Console Plug
and the Roof Panel (page 11) .
Figure 13
1. Bolt (1/4 x 1 inch) 3. Roof-support bracket
2. Sealing washer (1/4 inch) 4. Roof panel
2. Lift the roof panel straight up and remove it from the
cab of the machine.
Note:
Be careful when you set the roof panel down to
avoid damaging the surface and edges of the panel.
3. Remove the plug from the overhead console ( Figure
14 ).
Figure 14
1. Overhead console 2. Plug
Installing the Washer-Fluid Tank
1. Assemble the washer-fluid tank to the tank-support
bracket with the 2 carriage bolts (5/16 x 3/4 inch) and
2 flanged locknuts (5/16 inch) as shown in
Figure 15 .
Figure 15
1. Carriage bolt (5/16 x 3/4
inch) 3. Hole (washer fluid tank)
2. Hole—square (tank
support bracket for
HD-series models—221 x
168 mm (8-11/16 x 6-5/8
inch) with 45° flange) 4. Flanged-locknut (5/16
inch)
2. Torque the flanged locknuts to 1,987 to 2,542 N∙cm
(175 to 225 in-lb).
3. Locate the 2 holes 6.3 mm (1/4 inch) at the center of
the rear panel of the cab (
Figure 16 ).
Note:
The holes are spaced apart 178 mm (7 inches).
6