Toro 130-5615, Руководство по установке

Страница: 8 / 20

Connecting the Hose to the Wiper
1. At the overhead console, route 1 end of the hose (3/16
inch) through the hole in the overhead console (
Figure
20 ).
Figure 20
1. Hole (overhead console) 4. Barbed hose fitting
2. Bulb seal 5. Hose (wiper arm)
3. Hose (3/16 inch)
2. Insert the small end of the barbed hose fitting into the
end of the hose from the wiper arm until the fitting
fully seats (
Figure 20 ).
3. Insert the large end of the barbed hose fitting to the
end of the hose (3/16 inch) until the fitting fully seats
(
Figure 20 ).
Routing the Hose
1. Route the hose (3/16 inch) to the left of the overhead
console along the bulb seal at the front of the cab
frame (
Figure 21 ).
Figure 21
1. Hose (3/16 inch) 4. Pillar B (cab frame)
2. Hole (overhead console) 5. Front of the machine
3. Bulb seal
2. Route the hose rearward along the left frame channel
of the cab (
Figure 21 ).
3. Route the free end of the hose into the opening at the
top of the driver’s side pillar B of the cab frame, and
down through the frame (
Figure 22 ).
Note:
Use a stiff piece of wire, about 173 cm (68
inch) long, to pull (fish) the hose through pillar B of
the cab frame.
Figure 22
1. Hose (3/16 inch) 2. Pillar B (cab frame)
4. Route the free end of the hose across the back of the
cab, and align the hose with the barbed fitting in the
washer pump (
Figure 23 ).
Figure 23
1. Front of the machine 3. Barbed fitting (washer
pump)
2. Hose (3/16 inch)
8