Toro 130-5615, Руководство по установке

Страница: 15 / 20

Connecting the Wire Harness at the
Overhead Console
1. At the overhead console, route the 2-pin connector
end of the wire harness for the washer pump through
the hole in the overhead console (
Figure 43 ).
Figure 43
1. Hole (overhead console) 3. Washer pump wire
harness
2. 2-socket connector (cab
wire harness) 4. 2-pin connector (washer
pump wire harness)
2. Align the 2-pin connector of the washer pump wire
harness to the 2-socket connector of the cab wire
harness (
Figure 43 ).
3. Push the 2 connectors together until the connector
secures (
Figure 43 ).
4. Route the 2-socket connector of the wire harness for
the washer pump to the left of the overhead console
along the bulb seal at the front of the cab frame (
Figure
43 ).
Routing the Wire Harness
1. At the overhead console, route the wire harness for the
washer pump (
Figure 44 ) to the left and along side of
the hose installed in Routing the Hose (page 13) .
Figure 44
1. Overhead console 3. Pillar A (driver’s side)
2. Washer pump wire
harness
2. Route the 2-socket connector of the wire harness into
the opening at the top of pillar A (driver’s side) of the
cab frame and down to the hole at the bottom of the
pillar (
Figure 45 ).
Note:
Use a stiff piece of wire, about 130 cm (51
inch) long, to pull the wire harness through pillar A of
the cab frame.
15