Toro 130-5615, Руководство по установке

Страница: 10 / 20

Routing the Wire Harness
1. At the overhead console, route the wire harness for the
washer pump (
Figure 26 ) to the left and along side of
the hose installed in Routing the Hose (page 8) .
Figure 26
1. Washer pump wire
harness 4. Pillar B (cab frame)
2. Hole (overhead console) 5. Front of the machine
3. Bulb seal
2. Route the wire harness rearward along the left frame
channel of the cab (
Figure 26 ).
3. Route the 2-socket connector of the wire harness into
the opening at the top of the driver’s side pillar B of the
cab frame and down through the frame (
Figure 27 ).
Note:
Use a stiff piece of wire, about 173 cm (68
inch) long, to pull the wire harness through pillar B of
the cab frame.
Figure 27
1. Washer pump wire
harness 2. Pillar B (cab frame)
4. Route the wire harness for the washer pump across the
back of the cab, and aligned to the 2-blade connector
in the washer-pump motor (
Figure 28 ).
Figure 28
1. Front of the machine 4. 2-blade connector
(washer-pump motor)
2. Pillar B (cab frame) 5. 2-socket connector
(washer pump wire
harness)
3. Washer pump wire
harness
Connecting the Wire Harness to the
Washer Pump
1. Align the 2-socket connector of the wire harness to the
2-blade connector of the washer pump (
Figure 29 ).
Figure 29
1. 2-blade connector (washer
pump) 2. 2-socket connector
(washer pump wire
harness)
2. Push the wire-harness connector onto the pump until
the connector fully seats (
Figure 29 ).
10