Toro 130-5615, Руководство по установке

Страница: 14 / 20

down to the hole at the bottom of the pillar ( Figure 39
and Figure 40 ).
Note:
The hole is about level with the midpoint in
the dash
Note:
Use a stiff piece of wire, about 130 cm (51 inch)
long, to pull the hose through pillar A of the cab frame.
3. Route the free end of the hose forward, between the
electrical mounting plate and the fender to the machine
(
Figure 40 and Figure 41 ).
Figure 40
1. Hole—pillar A (driver’s
side) 3. Electrical mounting plate
2. Hose (3/16 inch)
Figure 41
1. Washer pump 4. Fender
2. Electrical mounting plate 5. Front of the machine
3. Hose (3/16 inch)
4. Route the free end of the hose inboard toward the
washer-fluid tank (
Figure 41 ).
Connecting the Hose to the Pump
1. At the washer-fluid tank, if needed, cut the hose to
remove excess hose length.
2. Align the end of the hose to the barbed fitting in the
washer pump (
Figure 42 ).
Figure 42
1. Washer-pump motor 3. Hose
2. Barbed fitting
3. Push the hose onto the fitting until the hose fully seats
onto the fitting (
Figure 42 ).
14