Figure 16
1.
Holes—6.3 mm (1/4 inch)
4.
Use an awl or punch to open a hole through the interior
foam panel (
) at the hole locations that you
identified in step
.
Note:
Use caution when working with sharp awl or
punch.
Figure 17
1.
Hole locations 6.3 mm (1/4
inch)—interior foam panel
2.
Awl or punch
5.
Assemble the 2 carriage bolts (1/4 x 1-1/4 inches),
strap, and 2 spacers (1/4 inch) to the holes that you
made in the interior foam panel (
).
Figure 18
1.
Carriage bolt (1/4 x 1-1/4
inches)
3.
Spacer (1/4 inch)
2.
Strap
4.
Hole location 6.3 mm (1/4
inch)—interior foam panel
6.
Assemble the tank-support bracket and washer-fluid
tank (
) onto the 2 carriage bolts (1/4 x 1-1/4
inches) with the 2 flanged locknuts (1/4 inch).
Figure 19
1.
Carriage bolt (1/4 x 1-1/4
inches)
3.
Flanged locknut (1/4 inch)
2.
Hole (tank-support
bracket)
7.
Torque the flanged locknuts to 1,017 to 1,243 N∙cm
(90 to 110 in-lb).
7
