Toro 08839, Руководство оператора

Страница: 14 / 64

8. Align the hole in the rod end of the drawbar with
the holes in the drawbar mount of the rear-frame
bulkhead (
Figure 13 ).
g361586
Figure 13
1. Locknut (3/4 inch) 4. Capscrew (3/4 x 4-1/2
inches)
2. Rod end (drawbar) 5. Spacers
3. Drawbar mount
(rear-frame bulkhead)
9. Assemble the rod end to the mount with the
capscrew (3/4 x 4-1/2 inches), 2 spacer, and
locknut (3/4 inch) as shown in
Figure 13 .
10. Torque the capscrew and locknut to 320 to 396
N∙m (238 to 392 ft-lb).
Assembling the Drawbar Chains
to the Lift Frame
1. Cross the attached chains from the ( Figure 14 )
over the drawbar.
g392371
Figure 14
1. Short drawbar chain
(17-1/2 inches) 4. Flange locknut (5/16 inch)
2. Flange-head bolt (5/16 x
1 inch) 5. Tow-stop bracket
(drawbar)
3. Washer (3/8 x 7/8 inch)
2. Pull the slack from the chain and align the link
to the hole in the tow-stop bracket of the of the
drawbar.
Ensure the link is flush to the outboard side of
the bracket, and the next link forward aligns into
the groove in the bracket.
3. Assemble the chain to the stop bracket with a
flange-head bolt (5/16 x 1 inch), washer (3/8
x 7/8 inch), and flange locknut (5/16 inch) as
shown in
Figure 14 .
4. Repeat steps 1 through 3 for the other chain at
the other side of the stop bracket.
5. Where the chains cross ( Figure 15 ), assemble
them with a flange-head bolt (3/8 x 1-1/2 inches)
and flange locknut (3/8 inch).
g392382
Figure 15
1. Flange locknut (3/8 inch) 3. Flange-head bolt (3/8 x
1-1/2 inches)
2. Connect the chains
through the 6th link from
the tow-stop bracket on
each chain 4. Short drawbar chains
6. Torque the 5/16 inch flange-head bolts and
locknuts to 19.8 to 25.4 N∙m (175 to 225 in-lb).
7. Torque the 3/8 flange-head bolt and locknut to
37 to 45 N∙m (27 to 33 ft-lb).
14