Toro 03820, Руководство оператора

Страница: 24 / 56

g008886
Figure 32
1. Hydraulic-tank cap
3. Remove the cap.
4. Remove the dipstick from the filler neck and
wipe it with a clean rag. Insert the dipstick into
the filler neck; then remove it and check the fluid
level. The fluid level should be within 6 mm (1/4
inch) of the mark on the dipstick.
5. If the level is low, add the appropriate fluid to
raise the level to the full mark.
6. Install the dipstick and cap onto the filler neck.
Checking the
Reel-to-Bedknife Contact
Each day before operating, check the reel-to-bedknife
contact, regardless of whether the quality of cut had
previously been acceptable. There must be light
contact across the full length of the reel and the
bedknife (refer to Adjusting the Reel to Bedknife in the
cutting unit
Operator's Manual ).
Checking the Tire Pressure
Service Interval: Before each use or daily
The tires are over-inflated for shipping. Therefore,
release some of the air to reduce the pressure.
Model Correct tire pressure
03820 83 kPa (12 psi)
03821 138 kPa (20 psi)
Note:
Maintain the recommended pressure in all tires
to ensure a good quality of cut and proper machine
performance.
DANGER
Low tire pressure decreases machine side hill
stability. This could cause a rollover, which
may result in personal injury or death.
Do not underinflate the tires.
Torquing the Wheel Nuts
Service Interval: After the first hour
After the first 10 hours
Every 200 hours
Torque the wheel nuts to 103 to 127 N∙m (76 to 94
ft-lb).
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Maintain proper torque of the wheel nuts.
Positioning the Seat
Changing the Seat Position
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable
1. Move the lever sideways to unlock the seat
(
Figure 33 ).
2. Slide the seat to the desired position and release
lever to lock it in position.
Changing the Seat Suspension
The seat can be adjusted to provide a smooth and
comfortable ride. Position the seat where you are
most comfortable.
To adjust it, turn the front knob in either direction to
provide the best comfort (
Figure 33 ).
Changing the Back Position
The back of the seat can be adjusted to provide a
comfortable ride. Position the back of the seat where
it is most comfortable.
To adjust it, turn the knob, under the right-side
armrest, in either direction to provide the best comfort
(
Figure 33 ).
Changing the Armrest Position
You can adjust the armrests to provide a comfortable
ride. Position the armrests where they are most
comfortable.
24