Toro 03820, Руководство оператора

Страница: 33 / 56

Understanding the Warning
System
If a warning light comes on during operation, stop the
machine immediately and correct the problem before
continuing operation. Serious damage could occur if
you operate the machine with a malfunction.
Mowing Grass
Start the engine and move the throttle to the F
AST
position. Move the Enable/Disable switch to the
E
NABLE
position and use the Lower Mow/Raise lever
to control the cutting units (the front cutting units
are timed to lower before the rear cutting units). To
move forward and cut grass, press the traction pedal
forward.
Driving the Machine in Transport
Mode
Move the Enable/Disable switch to the D
ISABLE
position and raise the cutting units to the transport
position. Move the Mow/Transport lever to the
T
RANSPORT
position. Be careful when driving between
objects so that you do not accidentally damage the
machine or the cutting units. Use extra care when
operating the machine on slopes. Drive slowly and
avoid sharp turns on slopes to prevent roll-overs.
After Operation
After Operation Safety
General Safety
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator’s position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the cutting units,
drives, mufflers, cooling screens, and engine
compartment to help prevent fires. Clean up oil or
fuel spills.
•
Shut off the fuel while storing or hauling the
machine.
•
Disengage the drive to the attachment whenever
you are hauling or not using the machine.
•
Maintain and clean the seat belt(s) as necessary.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Identifying the Tie-Down
Points
g198911
Figure 42
1. Tie-down loops
Hauling the Machine
•
Use full-width ramps for loading the machine onto
a trailer or truck.
•
Tie the machine down securely.
Towing the Machine
In case of an emergency, you can tow the machine for
a short distance; however, Toro does not recommend
this as a standard procedure.
Important:
Do not tow the machine faster than 3
to 4 km/h (2 to 3 mph) because the drive system
may become damaged. If the machine must be
moved a considerable distance, transport it on a
truck or trailer.
1. Locate the bypass valve on the pump ( Figure
43 ) and rotate it 90°.
g008892
Figure 43
1. Bypass valve
33