Toro 03820, Руководство оператора

Страница: 16 / 56

g012628
Figure 15
1. Hood-latch bracket 2. Rivets
3. While aligning the mounting holes, position the
CE lock bracket and the hood-latch bracket onto
the hood.
Note:
The lock bracket must be against the
hood ( Figure 16 ). Do not remove the bolt and
nut assembly from the lock-bracket arm.
g012629
Figure 16
1. CE lock bracket 2. Bolt and nut assembly
4. Align the washers with the holes on the inside of
the hood.
5. Rivet the brackets and the washers to the hood
(
Figure 16 ).
6. Hook the latch onto the hood-latch bracket
(
Figure 17 ).
g012630
Figure 17
1. Hood latch
7. Screw the bolt into the other arm of the hood-lock
bracket to lock the latch in position (
Figure 18 ).
Note:
Tighten the bolt securely but do not
tighten the nut.
g012631
Figure 18
1. Bolt 3. Arm of hood-lock bracket
2. Nut
5
Using the Cutting-Unit
Kickstand
Parts needed for this procedure:
1 Cutting-unit kickstand
Procedure
Whenever you tip a cutting unit to expose the
bedknife/reel, prop up the rear of the cutting unit with
the kickstand to ensure that the nuts on the back end
of the bedbar adjusting screws are not resting on the
work surface (
Figure 19 ).
16