Toro 03763, Руководство по установке

Страница: 18 / 24

Removing the Groomer
Drive Box
Note:
Retain all removed parts for later installation
unless otherwise stated.
Important:
If you have any issues removing the
groomer drive box, refer to your traction unit
Service Manual or contact your authorized Toro
distributor.
1. Remove the cap from the groomer.
2. Remove the clamp bolts connecting the groomer
to the drive box (
Figure 16 ).
3. Remove the shoulder bolt and hardened washer
connecting the groomer drive box to the adjuster
arm (
Figure 29 ).
g346932
Figure 29
1. Shoulder bolt 3. Groomer drive hex-head
2. Hardened washer 4. Reinforcement screw
4. Restrain the reel for removal; refer to Restraining
the Reel for Removing Threaded Inserts (page
19)
.
5. Install the reinforcement screw (Part No.
1-803022—sold separately) to the internal
threads of the groomer drive hex head and
torque to 13.5 N
⋅
m (120 in-lb) as shown in
Figure 29 .
6. Remove the groomer drive box from the cutting
reel by turning the groomer drive hex-head
(
Figure 29 ).
Important:
If the groomer drive box is
installed on the right side of a cutting
unit, turn the groomer drive hex-head
counter-clockwise (right-hand thread) to
remove the drive-box shaft from cutting unit.
Important:
If the groomer drive box is
installed on the left side of a cutting unit,
turn the groomer drive hex-head clockwise
(left-hand thread) to remove drive-box shaft
from cutting unit
Important:
You must use a 6-point socket
with heavy wall.
Cleaning the Grooming
Reel
Service Interval: After each use
Clean off the grooming reel after using it by spraying
it with water. Do not direct the water stream
directly at the groomer bearing seals. Do not permit
the grooming reel to stand in water so that the
components rust.
Inspecting the Blades
Service Interval: Before each use or daily
Inspect the grooming-reel blades frequently for
damage and wear. Straighten bent blades with a
pliers and replace worn blades. When inspecting the
blades, check to see that nuts on the right and left
blade-shaft ends are tight.
g010613
Figure 30
1. Grooming blade 3. Sharp edges
2. Dull (rounded) edges
18