Toro 03763, Руководство по установке

Страница: 10 / 24

g240752
Figure 16
1. Drive-stub shaft 4. Shaft clamp (4)
2. Groomer assembly 5. Bolt (4) Torque to 5 to 7
N∙m (46 to 60 in-lb)
3. Jam nut (4)
3. Secure the groomer to the machine as shown in
Figure 16 and snug the bolts.
4. To prevent binding, set the height of cut and
height of groom, then loosen the bolts.
Note:
To set the height of cut refer to your
cutting unit Operator’s Manual ; refer to Adjusting
the Groomer Height (page 14) for adjusting the
height of groom.
5. Torque the bolts to 5 to 7 N∙m (46 to 60 in-lb).
6. Check and adjust height of cut and height of
groom as necessary.
Installing the Broomer Kit
Part Number Broomer Kit
132-7115 18-inch Broomer Kit
132-7125 22-inch Broomer Kit
133-8222 27-inch Broomer Kit
1. Obtain an optional broomer kit for groomer
blade cartridges appropriate for your needs and
cutting unit; refer to the table above.
2. Loosen the groomer blade-retaining nuts on
each end of the groomer shaft (
Figure 17 ).
g032403
Figure 17
1. Strap buckle 3. Strap
2. Retaining nut 4. Brush
3. From 1 side of the groomer reel, slide a brush
into each groove around the full length of the
groomer reel (
Figure 18 ).
g227786
Figure 18
22 inch groomer shown
1. Strap 3. Toward rear of machine
2. Brush
4. Verify that the brushes are seated in the groomer
blade slots (
Figure 17 and Figure 19 ).
10