Toro 03763, Руководство по установке

Страница: 14 / 24

Adjusting the Groomer
Height
1. Park the machine on a clean and level surface,
lower the cutting units completely to the ground,
shut off the engine, engage the parking brake,
and remove the key.
2. Make sure that the rollers are clean and the
cutting unit is set to the desired height-of-cut
(see your cutting unit
Operator’s Manual ).
3. Rotate the quick-up levers ( Figure 23 ) to the
E
NGAGED
position (the handle points toward the
front of the cutting unit.
Important:
Use the Height-of-Cut (HOC) and
Height-of-Groom (HOG) recommended range
chart for setting the gauge bar.
4. At 1 end of the groomer reel, measure the
distance from the lowest tip of the groomer blade
to the working surface (
Figure 23 ). Turn the
height adjuster knob ( Figure 23 ) to raise or lower
the groomer blade tip to the desired height.
g346928
Figure 23
1. Height adjuster knob 3. Groomer height (HOG)
2. Quick-up lever 4. Number of rear roller
spacers (below side plate
pad)
5. Repeat step 4 at the opposite end of the
groomer, then check the setting on the first side
of groomer.
The height setting on both ends of the groomer
should be identical. Adjust the height as
required.
14