Tornadoo 99414, Руководство по эксплуатации и техническому обслуживанию

Страница: 12 / 15

12
6. Holding the handle bar firmly,
lift the front part of the machine
making it rotate onto the rear
wheels bringing it into the vertical
position as shown in the figure.
Brush cleaning
Disassemble the brush and clean it
with water (for the disassembly see
“BRUSH DISASSEMBLY
/ASSEMBLY”).
NOTE: Make sure that the tanks
are empty before disassembling the
brush.
Brush disassembly/assembly
1. Tip the machine backwards (see
under “POSITIONING OF THE
MACHINE FOR
MAINTENANCE AND
PARKING") pay attention and
remember to switch off the main
switch and to empty the tanks
before tipping over the machine.
2. With the machine in this
position rotate the brush
clockwise, as indicated in the
figure, until it is released from the
seat of the brush holder plate.
3. To reassemble the brush, insert
the coupling buttons on the brush
into the slots of the brush holder
plate and rotate counterclockwise
until it locks.
ATTENTION:
The handling of the brush operation
must be carried out using suitable
gloves to protect both mechanically
from contact with the bristles and the
chemical risk of contact with
dangerous solutions.
Squeegee cleaning
Keeping the squeegee clean
guarantee the best drying action.
1. Tip the machine backwards (see
under “POSITIONING OF THE
MACHINE FOR
MAINTENANCE AND
PARKING"). Remember to switch
off the main switch and to empty
the tank before tipping the
machine.
2. With the machine in this
position clean the internal part of
the squeegee inlet, eliminating dirt
build up, and clean the squeegee
rubbers.
ORDINARY MAINTENANCE
Brush wear control device
A safety device stops the brush
motor when the brush reaches a
low bristle level of about 10mm.
To restore the machine to proper
working order replace the brush
(see under “BRUSH
DISASSEMBLY/ASSEMBLY”).
Brush replacement
The brush has to be replaced when
the brush wear indicator activates.
It is possible to use other brush
types, depending on condition of
the floor to be cleaned.
Disassemble the old brush and
replace it with a new one (see
under “BRUSH
DISASSEMBLY/ASSEMBLY").
Rear squeegee replacement
Check the rear squeegee wear and
either turn or replace it.