Tornadoo 99414, Руководство по эксплуатации и техническому обслуживанию

Страница: 10 / 15

10
solution flow will be activated
automatically by pressing the
brush activation levers (7).
Releasing these levers, will stop
the flow automatically.
7. Pressing the brush activation
levers (7) the brush will start
rotating. The solution flow begins
to flow and the squeegee will start
drying the floor.
8. During the first few feet check
the solution flow lever. The
solution flow adjustment is preset
at the factory to satisfy the
cleaning of most floors. If it is
necessary to adjust the quantity of
solution onto the floor, adjust the
solution flow lever (11).
9. When moving the machine
backwards, make sure that the
squeegee is lifted.
Handle bar adjustment
When approaching obstacles or
walls, it is possible to better handle
the machine by adjusting the
handle bar to a more upright
position.
To rotate the handle bar:
1. Lift up on the release lever (8)
2. Rotate the handle bar into the
new working position keeping the
release lever (8) pulled.
3. Release the lever (8) to lock the
handle bar.
Once the obstacle has been passed
repeat the operation to return to the
previous working position.
This operation is also possible with
the machine in motion by
temporarily holding the handle bar
release levers (8).
Overflow device
In order to avoid serious damage to
the vacuum motor, the machine is
equipped with a float that activates
when the recovery tank is full,
closing the vacuum hose and
stopping the suction.
When this happens, it is necessary
to empty the recovery tank.
1. Switch off the machine pressing
the main switch.
2. Take off the vacuum filter cover
(19) after turning the levers (18).
3. Take off the squeegee hose (17).
4. Lift and remove the recovery
tank (16) pulling it by its handles,
one on the front and one on the
rear of the tank. Empty the
recovery tank into appropriate
containers, according to the
standard norms for the liquid
disposal.
5. Reassemble everything.
ATTENTION:
This operation must be carried out
using gloves to protect from
contact with dangerous solutions.
Security device brush lift
A security device shuts off the
brush motor when, for any reason,
the brush is lifted off the floor
during operation. To check this
operation, push down on the
handle so that the brush is lifted
off the floor. The brush should
stop rotating. When returned to
the normal working position the
brush should start rotating again.
STOPPING THE MACHINE
AFTER CLEANING
OPERATION
Before carrying out any type of
maintenance:
1. Switch off the main switch (1).