Tornadoo 99414, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 15

9
cycles, providing for the recharge
only when the red signal of
discharged batteries is activated.
In fact, an extended series of
charging cycles carried out when
the batteries still have a residual
charge, causes a battery to
deteriorate, shortening the battery
life.
NOTE: Never leave batteries
completely discharged even if the
machine is not used.
During the recharging operation a
device is activated that restricts the
machine from functioning.
Bring the machine on a level
surface near a suitable outlet.
Switch off the main switch (1).
Connect the main cable supplied
with the machine both to the
machine and to the outlet socket as
indicated in the figure.
At the end of the charging phase
take off the main cable.
ATTENTION:
Never charge batteries with a non-
suitable charger. Strictly follow the
instructions supplied by the battery
and charger manufacturer.
Battery disposal
It is mandatory to hand over
exhausted batteries, classified as
dangerous waste, to an authorized
institution according to the local
laws.
Recovery tank
Check that the cover of the
vacuum filter (19) is correctly
secured, after rotating the levers
(18). Furthermore, check that the
squeegee hose is correctly seated
in its seat (17).
Solution tank
The capacity of the solution tank is
indicated in the technical data.
Remove the solution tank cap (15)
placed in the top part of the
machine and fill the solution tank
with clean water at a maximum
temperature of 122°F (50°C). Add
liquid detergent in the percentage
and conditions recommended by
the manufacturer. To avoid
excessive foaming, which could
cause problems to the vacuum
motor, use the minimum
percentage of detergent. Screw
down the cap to close the tank.
ATTENTION:
Use always low foam detergent.
To avoid excessive foaming,
before starting working operation,
add into the recovery tank a
minimum quantity of anti-foam
product.
Never use pure acid.
FLOOR CLEANING
Starting the machine
The push buttons on the instrument
board are equipped with an upper
green signal light that will light
when the control is activated.
1. Switch on the machine pressing
the main switch (1).
2. Check the battery charge level
(see under “BATTERY
RECHARGING”).
3. Lower the squeegee by rotating
the handle of the squeegee lifting
lever (5) placed in the center of the
handle bar.
4. Press the switch for the brush
motor (2).
5. Press the switch for the vacuum
motor (3).
6. Press the switch for the solenoid
valve (4).
The machine is equipped with a
solenoid valve, therfore the