
9
RECOVERY TANK
Check that the cover of the suction filter
(1) is correctly secured, after rotating the
levers (B). Also check that the squee-
gee hose is correctly seated (A).
SOLUTION TANK
Remove the cap (6) on top of the tank
and fill the solution tank with clean
water at a maximum temperature of
122°F (50°C). Add the liquid detergent
in the percentage recommended by
the manufacturer. To avoid excessive
foaming, which could cause problems
to the vacuum motor, use the minimum
percentage of detergent. Screw down
the plug to close the tank
ATTENTION:
Always use low foam detergent. To
avoid excessive foaming, before starting
operation, add into the recovery tank a
quantity of anti-foam product as recom-
mended by the product manufacturer.
Never use acid.
FLOOR CLEANING
STARTING OF THE MACHINE
The push buttons on the instrument
panel are lit with a green signal LED that
shows the activation of each control.
1. Switch on the machine by pressing
the on/off switch (1).
2. Check the battery charge level (see
under “BATTERY CHARGING”).
3. Lower the squeegee by rotating the
handle of the squeegee lifting lever (5),
placed on the rear of the handle bar,
down.
4. Press the switch for the brush motor
(2).
5. Press the switch for the vacuum mo
-
tor (3).
6. Press the switch for the solenoid
valve (4).
The machine is equipped with a sole
-
noid valve, which activates the solution
flow automatically when the control le
-
vers (7) are engaged. Releasing these
levers will stop the flow automatically.
7. Activate the levers (7) and push the
unit forward, the brush will start rotat-
ing. The solution flow begins and the
squeegee will start drying the floor.
8. During the first few feet check that the
solution flow is appropriate. The flow ad-
juster of the solution is already adjusted
at the factory to satisfy the cleaning of
most floors. If it is necessary to adjust
the quantity of solution onto the floor,
adjust the lever of the flow adjuster (8).
COMPLETE SQUEEGEE ROTATION
Thanks to the complete squeegee
rotation, it is possible to wash and dry
both in forwards and reverse. Following
the indicated drawings, the reversal of
the squeegee position is made easier,
permitting the drying in reverse.
Drying going forward
Reversal of squeegee position with
rotation to the right
Reversal of squeegee position with
rotation to the left
Drying going backwards
DRYING GOING BACKWARDS
With the squeegee positioned in the
front part of the machine it is possible
to dry where a traditional squeegee can
not. Below are some examples of how
to use the complete squeegee rotation.
Wash the interested surface (1).
Wash the surface (1).
Содержание 99617
Страница 3: ...3 NOTES...