
12
2 With the machine in this position
rotate the brush clockwise, as indicated
in the figure, until it is released from the
pins of the brush holder plate.
3. To reassemble the brush insert the
pins into the slots of the brush holder
plate and rotate counter-clockwise until
it locks.
It is possible to use other brush types,
depending on the floor type to be
cleaned and on its dirt conditions (see
under “RECOMMENDED BRUSHES”).
ATTENTION:
The handling of the brush operation
must be carried out wearing suitable
gloves to protect both from contact with
the bristles and dangerous solutions.
SQUEEGEE CLEANING
Keeping the squeegee clean guaran-
tees the best drying action.
1. Tip over the machine backwards
(see under “VERTICAL POSITION-
ING OF THE MACHINE") remember to
switch off the on/off switch and to empty
the tanks.
2. With the machine in this position
clean both the rubber squeegee blades
and the suction inlet. Also remove any
fibres (string or hair) that can prevent
the support from turning freely.
ORDINARY MAINTENANCE
REAR SQUEEGEE RUBBER RE-
PLACEMENT
Check the squeegee rubber wear and
turn or replace it, as needed.
For replacement:
1. Lower the squeegee by lowering the
handle lever (1) placed in the rear center
of the handle bar.
2. Rotate the squeegee outwards.
3. With the squeegee in this position
remove the wing nuts (2) to free the
squeegee.
4. Take off the of the squeegee hose (3)
and take off the squeegee.
5. Release the catch (4) of the rubber
blade clamp and take the rubber off to
turn it to a new side or replace it.
6. Check that the coupling and the
squeegee hose are not obstructed, clean
the entire assembly.
To reassemble the squeegee reverse the
operations above.
FRONT SQUEEGEE RUBBER RE-
PLACEMENT
Check the wear of the front squeegee
rubber and replace it if worn out.
For the replacement it is necessary to:
1. Lower the squeegee by lowering
the handle lever (1) placed in the rear
center of the handle bar.
2. Rotate the squeegee outwards.
3. With the squeegee in this position
tremove it and then take off the
rear squeegee rubber (see under
“REAR SQUEEGEE RUBBER
REPLACEMENT”).
4. Remove the wing nuts (5) in the up
-
per part of the squeegee body, separate
the two metal parts that form the squee
-
gee body to take off the front rubber.
5. Clean all the components with water.
To reassemble the squeegee reverse
the operations above.
TROUBLESHOOTING GUIDE
THE VACUUM MOTOR DOES NOT
WORK
1. Check the charge level of the bat-
teries (see under “BATTERY CHARG-
ING”).
2. Verify that the vacuum motor switch
is activated and the green signal lamp
is on.
3. Check the level in the recovery tank
(see under “OVERFILL PROTECTION”)
and if necessary, empty the tank.
If the problem persists, please contact
the authorized service center.
Содержание 99617
Страница 3: ...3 NOTES...