Topsoaring New Technology Co., LTD
Top Sky DLG Install Guide
TopskyInstallGuide-(English version).doc
Page 39 of 40
a little 3M77 and on they went.
A good thing to do when installing the patches: put on only one side at a time. Why? This way you don't
lose the location of the wing bolt holes you filed out previously. Install both patches on one side, then
take a tiny drill bit and drill through the wing completely through the pilot holes. Then, flip the wing
over and apply the patches to the other side and run the drill bit back through the holes you just made on
the opposite side. When you do the bottom side, take good note of where the wire-exit hole is in relation
to the front bolt hole, once again to keep you from losing it and drilling a hole in the wrong spot on the
wing.
Once they were in place and all cured (much faster than 4 days!!!) it was time to drill the holes out
bigger and put in the carbon sleeves into the wing for the hard points. The holes were drilled, and the
supplied carbon rod was cut to length per the instructions. Be sure to sand the rod good before cutting it,
that way the glue will have good bite when they are glued into place. The sleeves were glued in with thin
foam safe CA.
Then we hit our first road block... the supplied wing bolts did not fit the threaded holes in the pod. So it
was off to the hardware store and on to our next stopping point. Hopefully this one won’t be as long as
this last one!
Cutting the patches. My favorite tool again!
Patches ready to go!
Lay them approximately centered over the bolt holes Wet them out with thin CA
Drill the holes so you don’t lose them on the other side Then apply to the other side
