Topsoaring New Technology Co., LTD
Top Sky DLG Install Guide
TopskyInstallGuide-(English version).doc
Page 27 of 40
6.2.
Insert 0.5mm steel wire into the tube. Make sure the wire can move smoothly. Sand the wire with
300# sandpaper if not.
6.3.
Cut slots on rudder and elevator, put in the horn without glue, then adjust them into appropriate
position.
6.4.
Cut a piece of balsa wood. Put it at the end of the rudder rod tube. Trim the shape of the wood,
and make sure the rod doesn’t get pressure.
6.5.
Fix the tube onto the tail boom with fiberglass and epoxy.
6.6.
Make a Z bend on the wire with pliers.
6.7.
Reinstall the horns with wires connected.
6.8.
Power on the receiver, center the servo and then glue the horns on the control surface with fast
glue.
