Toppro T2208, Руководство пользователя, Страница: 27 / 52

DSP Control
Touch the switch in this window, you can engage and disengage the Gate for the
selected channel. It will illuminate to indicate that the Gate has been touched and
enabled. The LCD display shows the Gate setting in real time. Its parameters can change by
adjusting Threshold, Attack & Release control directly and use the Parameter Adjust knob to set
the value.
Please notice that only if the Gate control has been enabled can its parameters be adjusted.
The bar has 3 colors here, which indicate 3 status.
˙
Grey- the switch is OFF.
˙ Green- the switch is ON, there is signal input and the value is below threshold level, which
means it enables the gate function.
˙
Red- the switch is ON, but gate function not enable.
Touch it to set the level at which the gate will open. It can be set from 0 to -84 dB.
Touch it to set the time for the gate to change from closed to open, much like a
fade-in. It can be set from 0.5 to 200 ms.
Touch it to set the amount of time for the gate to go from open to fully close.
It can be set from 0.01 to 1 second.
Note: A fast release abruptly cuts off the sound once it has fallen below the
threshold, A slower release smoothly changes from open to closed, much like a slow fade out.
If the release time is too short a click can be heard when the gate re-opens.
The Gate grid shows level setting of threshold in
real time. Meter on the left indicates the input
signal’s level activity.
Touch anyone of these controls to enter corresponding page.
It is the same with that in Assign interface in section 6.3.
Note: you can also rename the selected channel by long pressing CHXX.
ON
Threshold
0.0dB
Attack
50mS
Release
100mS
Level LIMIT
(dB)
16
12
7
3
-1
-5
-10
-14
-18
-22
-26
-30
(dB)
4
8
13
17
21
25
30
34
38
42
46
50
CLIP
10
7
4
2
0
-2
-4
-7
-10
-20
-30
Select
Channel
Save Load
Copy
Channel
27
6