Toppro T2208, Руководство пользователя, Страница: 25 / 52

DSP Control
6.4 Channel interface
Touch it in Polarity to invert the phase of the selected channel's signal (to alter the
phase by 180°). If the phase reverse is active the button will illuminate. The LCD
display shows the phase reverse setting in real time. The Polarity control can be used to correct
audio signals which are out of phase as well as to cancel/reinforce each other.
Touch it in Delay Time can engage and disengage the delay for the selected channel.
It will illuminate to indicate that the delay has been pressed and enabled. The LCD
display shows the delay time in real time. It can be set 300ms at 48K Hz. Please notice that only
if the Delay button has been enabled can its parameter be adjusted.
When Delay icon is engaged, touch it in Delay Time and rotate the Parameter Adjust
knob can control the selected channel’s delay time.
Touch it, the function is the same as Link button.
Touch this control, it will illuminate as well as the button, signal from a selected
channel can be assigned to Main channel, for the details please refer to Assign
introduction in section 6.3.
Touch the switch ON to enable Gate function, then rotate Parameter Adjust knob or
slide long fader on the right LCD screen to adjust value of Threshold, which will show
in the middle box. During adjustment, corresponding figure change will show in the
Gate grid.
In this area, you can touch the grid area to enter Gate page, for the detail of Gate
function, please refer to the Gate introduction in section 6.5.
Solo
Mute
CH08
Parameter
Aux 1
-10.5dB
Delay Time
0.0mS
Polarity
INV.
Delay
Link
Main
Gate
Threshold Threshold
EQ
Compressor
0.0dB 0.0dB
Rock Drums
ON
ON Flat EQ
ON
Load Save
Left
Right
Pan
Select
Channel
Copy
Channel
-10.5dB
CH08
Bank Select
Left
Bank Select
Right
Long
Faders
All Faders
DCA
Assign
Channel
Gate
Comp
PEQ
GEQ
FX 1
FX 2 Routing
System
EQ
INV.
Delay
0.0mS
Link
Main
Gate
Threshold
0.0dB
ON
25
6