VoxiPlus
Advanced
INSTALLATION MANUAL
© 2008 TOPEX S.A.
page
16
The processor card has several optical indicators (LEDs) located on the front panel of the
TOPEX VoxiPLUS equipment, for showing the system status. There are three LEDs located towards
the right side of the panel and two built-in LEDs for each connector labeled RS 232, LAN, WAN.
Figure 9 – PGVoIP card connectors and indicators
On the front panel of the PGVoIP card, from left to right, we have:
A recessed reset button for the reset of the system (labeled RESET);
A serial connector (RJ45 type) for maintenance, programming and administration of the
equipment (labeled RS 232);
An Eth RJ45 connector for the connection to the local network (labeled LAN);
Another Eth RJ45 connector, for the connection to the external network (labeled WAN).
A group of three optical indicators (LEDs) that show the status of the device. The LED’s
significance is detailed in chapter 2.5 – Status Monitoring.
A pair of RJ45 connectors for E1 trunks (labeled E1/A and respectively E1/B);
2.4.2 GSM / UMTS Card
The GSM card that is used by TOPEX VoxiPLUS, is the interface for VoIP calls over mobile
networks and accomplishes the mobile functions of the equipment. The PCB of the GSM card
features internal connectors for mounting up to four Quad Band modules for GSM, GPRS/EDGE,
UMTS, or HSDPA/HUSPA mobile networks.
Figure 10 – GSM card connectors and indicators
Note:
The mobile modules installed on the equipment correspond to the client’s request and should
be chosen according to the specifications of the mobile networks in the area of operation.
You may ask for modules for different technologies and operating frequency bands (GSM 900,
DCS1800, PCS 1900, 3GPP, etc)
The card features four slots (holders) for SIM cards which correspond to the Mobile Modules
from the Board. Thus the SIM cards are numbered and every SIM card matches to the appropriate
module.
