![background image](http://html1.mh-extra.com/html/topcon/motorgrader/motorgrader_operators-manual_1128650164.webp)
Troubleshooting
Motorgrader System Five Operator’s Manual
7-14
NOTICE
NOTICE
If you go past the chisel mark, repeat the procedure
beginning with the blade rotated 1 foot clockwise beyond
the chisel mark.
If the value is within 1 or 2 degrees of 0, then rotation is accurately
compensated and no repairs are needed!
Figure 7-18.
If the value is more than beyond 2 degrees, then the problem is one or
more of the following:
Figure 7-19.
• Excess "slop" in the pin between the grader's hydraulic swivel
and the hose tray.
• Hose tray is bent and the guide rods are no longer attached to the
circle.
• The hole where guide rod is attached to circle is worn so the
guide rod is no longer held tight.
• Guide rods are weak and have too much flex.
These are physical wear areas that must be repaired for System Five
to cut accurate cross slope.
ENTER
EXIT
KNOB
VALVE
LASER
SONIC
KNOB
VALVE
LASER
SONIC
SYSTEM TEST
MAINFALL
ROTATION 2°
SLOPE
ENTER
EXIT
KNOB
VALVE
LASER
SONIC
KNOB
VALVE
LASER
SONIC
SYSTEM TEST
MAINFALL
ROTATION 5°
SLOPE
Содержание Motorgrader
